Winegard RP-SK01 ユーザーズマニュアル

1. Press and hold “POWER” for two seconds to turn on the interface 

box. Wait until the interface box finishes “connecting to antenna.” The 
TRAV’LER

®

 antenna may enter the search routine after ten seconds. 

2. Wait until the antenna has at least raised to a position in which the feed 

arm is parallel to the roof. Then, press “POWER” and “SELECT” at the 
same time. The antenna should stop moving.

3. Unplug the interface box. Continue with instructions for your model of 

replacement LNB.

1. Remove and set aside the two screws from the wider end of the 

underside of the integrated adapter. 

2. Carefully slide the LNB out from 

the integrated adapter. Disconnect 
the three cables from the LNB 
using a 

7

/

16

” wrench.

3. Connect the three cables running 

through the integrated adapter 
to ports 1–3 (in any order) on the 
replacement LNB. Tighten each 
cable until fingertight, and then use 
a 

7

/

16

” wrench to tighten a quarter 

turn more.

4. Slide the LNB into the integrated adapter, and re-install the two 

screws (removed earlier) through the integrated adapter and LNB. 

1. Remove and set aside the four 

nuts and bolts holding the LNB 
guard to the feed arm. Then, slide 
the LNB guard down the feed arm 
and toward the reflector.

2. Remove and set aside the two screws 

holding the LNB to the feed arm. 

3. Carefully slide the LNB out from the feed arm. Disconnect the four 

coax cables from the LNB using a 

7

/

16

” wrench.

4. Connect the four coax cables running through the feed arm to the 

replacement LNB. The coax cables can be connected in any order. 
Tighten the cables until fingertight, and then use a 

7

/

16

” wrench to 

tighten a quarter turn more.

5. Slide the LNB into the feed arm, and re-install the two screws 

(removed earlier) through the underside of the feed arm and 
replacement LNB. Tighten. 

6. Slide the LNB guard up the feed arm and over the LNB. The front of 

the LNB guard should be ~½

″ in front of the LNB and should not be 

touching the LNB. Install the four bolts through the four holes in the 
LNB guard. Thread a nut onto each bolt, and tighten. 

1. Remove and set aside the four 

nuts and bolts holding the LNB 
guard to the feed arm. Then, slide 
the LNB guard down the feed 
arm and toward the reflector.

2. Remove and set aside the two 

screws holding the LNB to the 
feed arm. 

3. Carefully slide the LNB out from the 

feed arm. Disconnect the coax cable 
from the LNB using a 

7

/

16

” wrench.

4. Connect the coax cable running through the feed arm to the 

replacement LNB. Tighten the cable until fingertight, and then use a 

7

/

16

” wrench to tighten a quarter turn more.

5. Slide the LNB into the feed arm, and re-install the two screws 

(removed earlier) through the underside of the feed arm and 
replacement LNB. Tighten. 

6. Slide the LNB guard up the feed arm and over the LNB. The front of 

the LNB guard should be ~½

″ in front of the LNB and should not be 

touching the LNB. Install the four bolts through the four holes in the 
LNB guard. Thread a nut onto each bolt, and tighten.