Cobra Electronics 650 ユーザーズマニュアル
Rapid Charger and Rechargeable Batteries
To Insert Batteries in Radio:
1. Remove belt clip by releasing belt clip latch and sliding clip up.
2. Push up on lock tab to remove battery cover.
3. Insert batteries according to polarity markings.
NOTE: Estimated operation time on full charge: 12 hours.
These rechargeable batteries must be recycled or disposed of properly in compliance with all applicable laws. They must not be thrown in the
rubbish bin. Some countries and local authorities require recycling and have established collection programs. Please contact your local waste
disposal authority for instructions.
WARNING: Do not put batteries into fire or expose to high heat. They may explode.
1. Remove belt clip by releasing belt clip latch and sliding clip up.
2. Push up on lock tab to remove battery cover.
3. Insert batteries according to polarity markings.
NOTE: Estimated operation time on full charge: 12 hours.
These rechargeable batteries must be recycled or disposed of properly in compliance with all applicable laws. They must not be thrown in the
rubbish bin. Some countries and local authorities require recycling and have established collection programs. Please contact your local waste
disposal authority for instructions.
WARNING: Do not put batteries into fire or expose to high heat. They may explode.
For Charging Cobra’s microTALK
®
Radio(s):
1. Check to see that the batteries have been inserted properly. See above for battery installation instructions.
2. Insert round connector of wall charger into the charge jack located at the top of the radio. The wall charger has two (2)
2. Insert round connector of wall charger into the charge jack located at the top of the radio. The wall charger has two (2)
round connectors which enables you to charge either one (1) or two (2) radios at a time.
3. Plug the wall charger into electrical outlet. It normally takes about 3 hours to fully recharge batteries.
It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 12 hours.
Use only the supplied rechargeable batteries and wall charger for recharging your Cobra microTALK
It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 12 hours.
Use only the supplied rechargeable batteries and wall charger for recharging your Cobra microTALK
®
radio. Non-rechargeable
alkaline batteries can also be used.
Radio Power
To Turn Your Radio On:
– Press and hold the MODE/POWER button until you hear a series of audible tones indicating that the radio is On.
Your microTALK
– Press and hold the MODE/POWER button until you hear a series of audible tones indicating that the radio is On.
Your microTALK
®
radio is now in LISTENING MODE, ready to receive transmissions. The radio is always in LISTENING MODE,
except when the TALK, CALL or MODE/POWER buttons are pressed.
To Turn Your Radio Off:
– Press and hold the MODE/POWER button for two (2) seconds.
To Turn Your Radio Off:
– Press and hold the MODE/POWER button for two (2) seconds.
Battery Low Indicator
When battery power is low, the BATTERY LOW indicator will blink, indicating that batteries should be recharged or replaced.
WARNING: Only the supplied NiMH batteries can be recharged.
WARNING: Only the supplied NiMH batteries can be recharged.
Battery/Power Saver
If there are no transmissions within 10 seconds, the unit will automatically switch to Battery Save mode and POWER SAVER
will appear in the display. This will not affect the unit’s ability to receive incoming transmissions.
will appear in the display. This will not affect the unit’s ability to receive incoming transmissions.
English
OPERATION
Lock Tab
Remove Belt Clip
Insert Batteries
Rapid Wall Charger
Mode/Power
Button
Button
Battery Low Icon
Power Saver Icon
Insert Connector