3com 3CR17451-91 ユーザーズマニュアル
Important Safety Information
55
WARNING: The appliance coupler (the connector to the unit and not the
wall plug) must have a configuration for mating with an EN60320/IEC320
appliance inlet.
wall plug) must have a configuration for mating with an EN60320/IEC320
appliance inlet.
WARNING: The socket outlet must be near to the unit and easily
accessible. You can only remove power from the unit by disconnecting
the power cord from the outlet.
accessible. You can only remove power from the unit by disconnecting
the power cord from the outlet.
WARNING: This unit operates under SELV (Safety Extra Low Voltage)
conditions according to IEC 60950. The conditions are only maintained if
the equipment to which it is connected also operates under SELV
conditions.
conditions according to IEC 60950. The conditions are only maintained if
the equipment to which it is connected also operates under SELV
conditions.
WARNING: France and Peru only:
This unit cannot be powered from IT
This unit cannot be powered from IT
†
supplies. If your supplies are of IT
type, this unit must be powered by 230V (2P+T) via an isolation
transformer ratio 1:1, with the secondary connection point labelled
Neutral, connected directly to earth (ground).
transformer ratio 1:1, with the secondary connection point labelled
Neutral, connected directly to earth (ground).
†
Impédance à la terre.
WARNING: U.K. only:
If connecting a modem to the console port of the Switch 3870, only use a
modem which is suitable for connection to the telecommunications
system.
If connecting a modem to the console port of the Switch 3870, only use a
modem which is suitable for connection to the telecommunications
system.
WARNING: RJ-45 Ports. These are shielded RJ-45 data sockets. They
cannot be used as standard traditional telephone sockets, or to connect
the unit to a traditional PBX or public telephone network. Only connect
RJ-45 data connectors, network telephony systems, or network
telephones to these sockets.
cannot be used as standard traditional telephone sockets, or to connect
the unit to a traditional PBX or public telephone network. Only connect
RJ-45 data connectors, network telephony systems, or network
telephones to these sockets.
Either shielded or unshielded data cables with shielded or unshielded
jacks can be connected to these data sockets.
jacks can be connected to these data sockets.
WARNING: When the Module is inserted into the switch, the two captive
thumbscrews securing the Module must be tightened with a suitable
thumbscrews securing the Module must be tightened with a suitable
Europe only:
■
The supply plug must comply with CEE 7/7 (“SCHUKO”).
■
The mains cord must be <HAR> or <BASEC> marked and
be of type H03VVF3GO.75 (minimum).
be of type H03VVF3GO.75 (minimum).
Denmark
■
The supply plug must comply with section 107-2-D1,
standard DK2-1a or DK2-5a.
standard DK2-1a or DK2-5a.
Switzerland
■
The supply plug must comply with SEV/ASE 1011.
DUA1745-0AAA03.book Page 55 Friday, April 8, 2005 12:34 PM