ICOM IC-F3022S ユーザーズマニュアル

4 - 1

 

CAUTION! Optional unit installation should be done at authorized Icom servise center only.

Install the optional unit as follows.

q Rotate [VOL] to turn the power OFF, and remove the 
     battery pack.
w Remove the unit cover as below. (The removed unit 
     cover can not be used again.)

NOTE: When uninstalling the unit
Be sure to re-solder the cut points as below when you 
remove the unit. Otherwise, no transmit modulation or 
receive AF output is available.

e Cut the pattern on the PC board at “MIC” and “DISC” 
    as below. (This modification is not necessary for
    UT-108R installation.)

r Install the unit as below.

Re-solder

t Remove the paper backing of the supplied unit cover,   
      and attach the unit cover and the battery pack, then
    rotate [VOL] to turn the power ON.

y Set or modify the scrambler or decoder settings using
    optional CS-F3020.