2WIRE F-116P ユーザーズマニュアル

4-59

1. Run Self-Test Mode: 

Turn the power on while pressing 

the test printing button for 2 or 3 seconds 

before printing works.

Check the power of the printer and perform 
the Self-Test. If the test printing works, that 
means no problems in the printer itself. 
If the test printing does not work, that 
means bad functioning of the printer
(not because of software).

Replace the printer cable. If the problems 
not solved even after the cable replaced, 
check the amount of the remaining tone.
(refer to Toner Cartridge Service 4-5)

Check if the connection between PC and printer 
port is proper. If you using windows, check if the 
printer driver in the controller is set up. If the printer 
driver is properly set up, check in which program 
the printing is not working. The best way to find out 
is to open the memo pad to check the function of 
printing. If it is not working in a certain program, 
adjust the setup the program requires. Sometimes, 

the printout is normal within the Windows basic
programs, but it's not working in a particular 
program. In such case, install the new driver again.  

If not working in the Windows basic program, 
Check the setup of the port of CMOS is on ECP. 
And check the address of  IRQ 7 and 378 

If the scanner needs to be connected to the 
printer, first the remove the scanner from 
the PC to see if the printer is properly 
working alone.

2. Check if the PC and the 

printer is properly connected and 

the toner cartridge installed.

3. Printing is not working in the Windows.

4. Check if the printer cable is 

directly connected to peripheral devices