Bolens 225E サービスマニュアル

6

•

With the clutch lever disengaged, pull starter rope 
slowly several times. The tines should not turn. If 
they turn, the cable is not adjusted properly. 

•

To adjust the cable, loosen the nut near the top of 
the cable and unscrew the cable to provide 
additional slack in wire. See Figure 3.

•

Tighten the nut and check again for proper 
adjustment. 

.

The clutch control lever is located on the left handle. 
Squeezing the lever against the handle engages the 
tine drive. Release the lever to stop the tines from 
turning. See Figure 4

The depth stake is located in the rear of the tiller and it 
controls the tilling depth. See Figure 4

The handle may be adjusted to the height desired. 
Loosen the handle adjustment lever a few turns and 
pivot handle up or down to desired position. Tighten 
lock. See Figure 4.

The throttle control lever is located on the engine. It 
controls the engine’s speed and stops the engine. 
•

With the throttle control pushed completely forward, 
the carburetor is in START or FAST position. Use 
maximum engine speed for deep tilling. 

•

Pull the throttle control back to reduce engine 
speed to IDLE. Throttle control should be at IDLE 
for transporting the tiller. 

•

Pull the throttle completely back to stop the engine.