Invacare R121 ユーザーズマニュアル
MAINTENANCE
36
The Invacare Patient Lift is designed to provide a maximum of safe, efficient and
satisfactory service with minimum care and maintenance.
satisfactory service with minimum care and maintenance.
All parts of the patient lift are made of the best grades of steel, but metal to metal contact
will wear after considerable use.
will wear after considerable use.
There is no adjustment or maintenance of either the casters or brakes, other than cleaning,
lubrication and checking axle and swivel bolts for tightness. Remove all debris, etc. from
the wheel and swivel bearings. If any parts are worn, replace these parts immediately.
lubrication and checking axle and swivel bolts for tightness. Remove all debris, etc. from
the wheel and swivel bearings. If any parts are worn, replace these parts immediately.
If you question the safety of any part of the lift, contact your dealer immediately and
advise them of the problem.
advise them of the problem.
Lubricating the Lift
NOTE: For this procedure, refer to FIGURE 7.1.
The Invacare lift is designed for minimum maintenance. However, a six month check and
lubrication should ensure continued safety and reliability.
lubrication should ensure continued safety and reliability.
Keep lift and slings clean and in good
working order. Any defect should be noted
and reported to your dealer as soon as
possible.
working order. Any defect should be noted
and reported to your dealer as soon as
possible.
The casters MUST swivel and roll
smoothly. A light grease (waterproof auto
lubricant) may be applied to the ball
bearing swivel of the casters once a year.
Apply more frequently if the casters are
exposed to extreme moist conditions.
smoothly. A light grease (waterproof auto
lubricant) may be applied to the ball
bearing swivel of the casters once a year.
Apply more frequently if the casters are
exposed to extreme moist conditions.
Lubricate all pivot points. Wipe all excess
lubricant from lift surface.
lubricant from lift surface.
Lubricate the following points:
• Swivel bar
• Boom mounting bracket
• Boom/mast mount
• Mast mounting bracket
• Swivel bar
• Boom mounting bracket
• Boom/mast mount
• Mast mounting bracket
FIGURE 7.1 Lubricating the Lift
Detecting Wear and Damage
It is important to inspect all stressed parts, such as slings, spreader bar and any pivot for
slings for signs of cracking, fraying, deformation or deterioration. Replace any defective
parts immediately and ensure that the lift is not used until repairs are made.
slings for signs of cracking, fraying, deformation or deterioration. Replace any defective
parts immediately and ensure that the lift is not used until repairs are made.
Mast Mounting
Bracket
Boom/Mast
Mount
Boom Mounting
Bracket
Swivel Bar