Golden Technologies Companion II ユーザーズマニュアル
28
Companion
4 Flashes
• Indicates that the motor control board is overloaded and overheated.
• An overload can occur if you have been driving your Companion for an extended
• Indicates that the motor control board is overloaded and overheated.
• An overload can occur if you have been driving your Companion for an extended
period of time up an incline that is steeper than the recommended grade (see “Speci-
fications” on page 9).
fications” on page 9).
• An overload can occur if your Companion is carrying a payload that is higher then
the recommended weight capacity. See “Specifications” on page 9 for your Companion
model weight capacity.
model weight capacity.
• An overload can also occur if your Companion’s tires are under inflated. Underinflated
tires cause the motor to draw large amounts of current. This high draw overheats
the motor control board.
the motor control board.
• Your scooter will not operate until the motor control board cools back to its opera-
tional temperature range.
Remedy:
• Turn off your Companion’s key switch and allow the motor control board to cool
• Turn off your Companion’s key switch and allow the motor control board to cool
to its operational range.
• Check the tire pressure. See section XI. “Care and maintenance.”
• Have your authorized Golden Technologies, Inc. dealer perform a battery load
• Have your authorized Golden Technologies, Inc. dealer perform a battery load
test.
5 Flashes
• Indicates a brake problem.
• The brake handle may be in the disengaged position. See section VIII. “Assembly.”
• The brake or the brake wiring may be damaged.
• For safety reason, your scooter was designed to cease operation until the problem is
• Indicates a brake problem.
• The brake handle may be in the disengaged position. See section VIII. “Assembly.”
• The brake or the brake wiring may be damaged.
• For safety reason, your scooter was designed to cease operation until the problem is
corrected.
Remedy:
• Make certain that the brake handle is in the engaged position. See section VIII.
• Make certain that the brake handle is in the engaged position. See section VIII.
“Assembly.”
• Turn the key switch to the “Off” position to stop the flash code.
• Set brake to the up “engaged” position.
• Turn the key back to the “On” position.
• If the above remedies do not solve the problem, contact your authorized Golden
• Set brake to the up “engaged” position.
• Turn the key back to the “On” position.
• If the above remedies do not solve the problem, contact your authorized Golden
Technologies, Inc. dealer.
DIAGNOSTICS
Companion Owner's Manual: GC222, GC223, GC322, GC323, GC325, GC421