Golden Technologies Companion II ユーザーズマニュアル

ページ / 41
Companion 
31
 
•  Contact your authorized Golden Technologies, Inc. dealer.
 
•  Do not keep resetting the main circuit breaker without correcting the un-
derlying electrical problem.
WHEELS AND TIRES
Golden Companion scooters are equipped with split-rim wheels with pneumatic and 
foam-filled tires.
CARE AND MAINTENANCE
FIGURE 46. WHEEL REMOVAL
CENTER 
NUT
WARNING:  Golden  Technologies,  Inc.  does 
not  recommend  that  you  disas-
semble the tire from the splitrim 
wheels. Consult your authorized 
Golden Companion dealer for as-
sistance with this matter. If you 
must  disassemble  a  pneumatic 
tire  from  the  split  rim,  the  tire 
must be completely deflated.
 
If the tire is not completely de-
flated, serious injury may occur.
To Change a Tire Assembly:
1. Completely deflate the tire. Failure to do so can cause injury.
  •  The front tire on the Companion I is a solid tire. Deflation is not possible.
2. Remove the center nut. See figure 46.
3. Remove the tire assembly from the scooter.
4. Install a new tire assembly or a repaired tire assembly (see the warning on this page) 
onto the axle.
5. Install and tighten the center nut.
6. Inflate the tire to the proper pressure.
  •  Rear pneumatic tires should not exceed 50 psi (pounds per square inch). This is 
a maximum tire pressure. Tires should never be inflated beyond that pressure.
  •  The front tire on the Companion II requires 50 psi.
  •  The front tire on the Companion I is a solid tire. It does not require air.
NOTE: Under-inflated tires will cause significant loss of operational range and
will also cause the motor control board to overheat.
Companion Owner's Manual:  GC222, GC223, GC322, GC323, GC325, GC421