Golden Technologies GA 531 ユーザーズマニュアル

ページ / 35
Avenger Owner’s Manual   
 
 
 
CARE AND MAINTENANCE 
 
Main Circuit Breaker  
 
The 50-amp circuit breaker and exposed reset button  
AreA located under the battery cover.  The button is visable 
through the battery cover.  If your Avenger
™ fails to  
operate, your main circuit  breaker may have tripped.  
 
WARNING:  DO NOT ATTEMPT ELECTRICAL 
REPAIRS.  CONSULT GOLDEN TECHNOLOGIES 
OR YOUR AUTHORIZED GOLDEN DEALER.
 
 
 
Possible causes for the main circuit breaker to trip:  
•  “Run-down” batteries.   
•  Over exerting the motor. 
 
Possible solutions:  
•  Recharge your batteries. 
•  If the problem persists, have an authorized Golden dealer “load test” the 
batteries to assure they are not damaged. 
•  If the problem persists, assure your battery charger is operating properly.  
 
Resetting the Main Circuit Breaker 
If the main circuit breaker trips as a result of “run-down” batteries or because of a 
temporary overload, reset the circuit breaker using the following directions: 
1.  Wait 5 minutes to allow the motor and electronics board to cool, or return 
to “normal” operating temperature. 
2.  Press in on the main circuit breaker reset button. 
 
WARNING:  BE SURE YOU REMOVE THE KEY FROM THE KEY RECEPTACLE BEFORE 
RESETTING YOUR SCOOTER. 
 
This is the 
“LED” light 
that will flash 
in the event 
of a problem. 
Circuit Breaker
 
 
Found on the rear of 
the unit next to the 
freewheel brake 
release.