Polycom 1725-36055-001 ユーザーズマニュアル
Cisco: 340 Access Point
PN: 1725-36055-001_G.doc
7
6. By default, WEP (Wired Equivalency Privacy) is off. If WEP is
desired, obtain the key values from the local administrator of the
wireless LAN and use the AP vendor documents for guidance in
programming the encryption settings.
wireless LAN and use the AP vendor documents for guidance in
programming the encryption settings.
Note the WEP settings. The handsets require configuration with
identical settings.
identical settings.
7. Navigate to
AP Radio > Hardware
.
The following table shows additional settings:
Hardware Parameter
Setting
Criticality
Allow broadcast SSID to
associate?
associate?
Yes Recommended
Data rates:
1.0
Basic
Required
2.0
Any
Required
5.5
Yes
or
no
Required
11.0
Yes
or
no
Required
Transmit power
30 mW
Recommended
Fragmentation threshold
584 or higher
Required
Beacon period (Kusec)
100
Recommended
Data beacon rate (DTIM)
2
Recommended
Receive antenna
Diversity
Recommended
Transmit antenna
Diversity
Recommended
8. After these parameters have been set, click
Apply
to accept these
settings.
9. Return to the
Setup
menu and select
Advanced
to the right of the
AP
Radio
section at the bottom of the screen. It is recommended that
the
Use Aironet Extensions
parameter be set to
No.
10. Return to the
Setup
menu and select
Advanced
to the right of the
AP
Radio
section at the bottom of the screen. It is recommended that
the
Change Radio Preamble
parameter be changed to
Long.
11. The Cisco 340 Access Point has SpectraLink Voice Priority (SVP)
active at all times. There is no parameter to enable or disable.
12. Restart the AP.
The AP is now ready for use with SpectraLink 8000 Wireless
Telephones.
Telephones.