MSB Technology Rev 1 (10 2012) ユーザーズマニュアル

5

Rear Panel Analog Details 
Analog Single-Ended RCA Output – This is the primary single ended RCA analog output. For optimum performance, use this output as

the DAC is fundamentally single-ended. 
Analog Balanced XLR Output – This is the balanced XLR analog output.  This is an alternate output format.
Analog Single-Ended RCA Input – This is the single-ended analog input.  This input is passed to the output with no change unless a volume 

option is installed. When the volume control is installed, this input is also. With advanced control options, this input can be either volume

controlled or not, depending on the menu settings. This input is ideal for adding a vinyl input to your system.  Minimum input impedance 

is 2 kohms.   At 0 dB volume setting, the analog inputs are a direct pass-through.  This input should be terminated when not in use.

Power Input – This product must be plugged into a Platinum power base with both analog and digital supplies.  It will work with both 

the Analog DAC desktop supply, Analog DAC power base or any of the DAC IV power bases.

Control Interface – This optional interface allows the DAC to be controlled using a web based system  This module would need to 

connect to a computer network.   
RS-232  – The RS-232 optional 

interface is used for controlling the 

DAC with a system controller.   

) 

The Analog DAC can accommodate 

up to three input modules at 

one time, but they can be easily 

swapped in and out as your 

system changes.  The order of the 

modules determines the priority of 

input selection in the auto select 

mode.  The highest priority input 

will always interrupt the lower 

priority.  So if you have a source 

that is always on, it should be 

set as the lowest priority so any 

other source can interrupt it.  The 

highest priority input is closest to 

the analog outputs.
Each module is described below.