Cobalt Networks 9011 ユーザーズマニュアル
9011 Owner’s Manual
••••
(V 1.0)
Page 14 of 22
Card Control and Status
Card Control Switches
The majority of the card control can be performed by the 8 switches on switch bank S1. Their operation
is detailed in the following table.
S1.1
S1.2
S1.3
VIDEO INPUT AND COLOR SEPARATION MODE
ON*
ON*
ON*
All Composite
ON
OFF
ON
BNC 7 – Y, BNC 8 – C, BNC 9 – Composite, BNC 10 – Composite
ON
OFF
OFF
BNC 7 – Y, BNC 8 – C, BNC 9 – Y, BNC 10 – C
OFF
ON
ON
BETACAM™ BNC 7 – Y, BNC 8 – Pr, BNC 9 – Pb, BNC 10 – Composite
OFF
ON
OFF
MII™ BNC 7 – Y, BNC 8 – Pr, BNC 9 – Pb, BNC 10 – Composite
OFF
OFF
ON
SMPTE BNC 7 – Y, BNC 8 – Pr, BNC 9 – Pb, BNC 10 – Composite
OFF
OFF
OFF
RGB BNC 7 – Y, BNC 8 – Pr, BNC 9 – Pb, BNC 10 – Composite
S1.4
OUTPUT COLOR ENABLE
ON*
Enable color on output
OFF
Disable color on output
S1.5
OUTPUT TEST PATTERN
ON
Enable 75% color bars as output pattern, regardless of input signal
OFF*
Disable output test pattern
S1.6
ENABLE SETUP/PEDESTAL ON NTSC OUTPUT
ON*
Output signal with 7.5 IRE setup/pedestal
OFF
Output signal with 0 IRE of pedestal
S1.7
ENABLE OUTPUT OVERSAMPLING
ON*
Output DAC runs at 2x SDI Y channel data rate (8:8:8 sampling)
OFF
Output DAC runs at 4x SDI Y channel data rate (16:16:16 sampling)
S1.8
ENABLE OUTPUT DEJITTER FILTER
ON*
DAC clock de-jitter filter enabled
OFF
DAC clock de-jitter filter disabled
Other, less used, parameters are adjusted by dialing S3 and S4 to certain values, and then moving the
thumb switch S2 up or down. These parameters are detailed in the following table. For any given parameters,
pressing the REGISTER RESTORE button (S5) will restore the parameter to it’s saved setting.
pressing the REGISTER RESTORE button (S5) will restore the parameter to it’s saved setting.
S3
S4
Internal Parameter
0
0
Normal card operation
1
1
Y Gain
1
2
Y Offset (Black level)
1
3
Color Saturation
1
4
Hue (for Composite and Y/C outputs only) +/-22.5º in 0.18º increments
1
5
SCH Phase
1
6
Sharpness –4dB to +4dB in 12 steps
2
7
VBI lines 10-20 Encoded (LED On = Encoded, Off = VBI Blanked)
5
0
Add setup/pedestal to odd lines 10-18 (NTSC only)
5
1
Add setup/pedestal to odd lines 19-25 (NTSC only)
5
2
Add setup/pedestal to even lines 10-18 (NTSC only)
5
3
Add setup/pedestal to even lines 19-25 (NTSC only)
5
4
Add setup/pedestal to all lines 10-25 (Note: overwrites settings of 5-0 through 5-3)
8
8
Restore Factory Defaults (Press S2 Up)
9
9
Save Settings (Press S2 Up)