Cobalt Networks 9033-SD ユーザーズマニュアル

••••  (V 1.1) 

Use the following steps to install the card in the openGear

TM

 8310 frame: 

1.  Refer to the Owner’s Manual of the openGear

TM

 8310 frame to ensure that the frame 

is properly installed according to instructions.   

 

 

 

Warning 

 

Heat and power distribution requirements within a frame may dictate 
specific slot placement of cards.  Cards with many heat-producing 
components should be arranged to avoid areas of excess heat build-up, 
particularly in frames using convection cooling. 

 

2.  After selecting the desired frame installation slot, hold the card by the edges and 

carefully align the card edges with the slots in the frame.  Then, fully insert the card 
into the frame until the rear connection plugs are properly seated on the midplane and 
rear modules. 

This completes the procedure for installing the card in the openGear

TM

 8310 frame. 

This section provides instructions for connecting cables to the installed BNC rear modules on the 8310 
series frame backplane. Connect the input and output cables according to the following diagram. The 
input is internally terminated with 75 Ohms.  It is not necessary to terminate unused outputs.  

 

 

 

 

 

 

 

In the near future, Cobalt Digital Inc. will release a series of rear modules that allow access to the full 
IO capabilities of the card. 

SD-SDI Input

Pb

Pr/C

AES IN/OUT 2

AES IN/OUT 1

AES IN/OUT 3

Y/CMPST

SD SDI Output 1

AES IN/OUT 4

SD SDI Output 2