Advantech 5000 Series マニュアル

目次

• Introduction

  1
• Overview

  1
• System Configuration

  1
• A Few Steps to a Successful System

  1
• Installation Guideline

  2
• General

  2
• Module Installation

  2
• I/O Slots and I/O Channel Numbering

  2
• Mounting

  2
• Wiring and Connections

  2
• ADAM-5000 System

  3
• Overview

  3
• Major Features of the ADAM-5000 System

  3
• System Setup

  3
• Technical Specifications of the ADAM-5000

  3
• I/O Modules

  4
• Software Utilities

  5
• Overview

  5
• Save Function

  5
• COM Port Settings

  5
• Terminal Emulation

  5
• Data Scope

  5
• Saving a Module’s Configuration to File

  5
• Load Module’s Configuration File

  5
• Module Configuration

  5
• Module Calibration

  5
• Data Input and Output

  5
• Alarm Settings

  5
• Download Procedure

  5
• DLL (Dynamic Link Library) Driver

  5
• DDE (Dynamic Data Exchange) Server

  5
• Command Set

  6
• Introduction

  6
• Syntax

  6
• CPU Command Set

  6
• ADAM-5013 RTD Input Command Set

  6
• Analog Input Command Set

  6
• ADAM-5017H Analog Input Command Set

  6
• Analog Input Alarm Command Set

  6
• Analog Output Command Set

  6
• 6.10 ADAM-5080 Counter/Frequency Command Set

  6
• Chapter 7 Troubleshooting

  7
• Hardware Diagnosis

  7
• Software Diagnosis

  7
• System Indicators

  7
• Communication Problems

  7
• I/O Module Troubleshooting

  7
• Figure 1-1 ADAM-5000 Configurations

  1
• Figure 2-1 ADAM-5000 Diagnostic indicators

  2
• Figure 2-2 ADAM-5000 Network address DIP switch

  2
• Figure 2-3 Module alignment and installation

  2
• Figure 2-4 ADAM-5000 Panel mounting

  2
• Figure 2-5 ADAM-5000 Rail mounting

  2
• Figure 2-6 ADAM-5000E Rail mounting

  2
• Figure 2-7 ADAM-5000 Wiring and connections

  2
• Figure 2-8 Built-in Communication Ports for Diagnostic

  2
• Figure 3-1 Function block diagram

  3
• Figure 5-1 Display the connected module

  5
• Figure 5-3 Setup options

  5
• Figure 5-4 Checksum function enabled

  5
• Figure 5-5 The connection for the Data Scope function

  5
• Figure 5-6 Monitor the issing commands from PC#1

  5
• Figure 5-7 Zero Calibration

  5
• Figure 5-8 Execute Zero Calibration

  5
• Figure 5-9 Span Calibration

  5
• Figure 5-10 Execute Span Calibration

  5
• Figure 5-11 CJC Calibration

  5
• Figure 5-12 Execute CJC Calibration

  5
• Figure 5-13 RTD Module Calibration

  5
• Figure 5-14 Analog Output Calibration

  5
• Figure 6-1 Baud rate codes

  6
• Figure 6-2 Analog module error codes

  6
• Figure 6-3 Data format for 8-bit parameters

  6
• Figure 6-2 Data format of 8-bit parameters

  6