ユーザーズマニュアル目次Cover1Table of Contents3Model Identification10Safety Information5General Safety Precautions5Important Safety Instructions6Locating an Authorized Servicer8Introduction9Customer Service9Troubleshooting111. WE-8 Control Has No Visible Display (P and N-Voltage Models)122. WE-8 Control Has No Visible Display (Q and X-Voltage Models)163. No Fill Analysis204. Water Runs Continuously into the Washer-Extractor245. Door Lock Switch Analysis: Display Shows “Door Error”286. Door Lock Switch Analysis: Display Reads “Please Close Door”327. Door Lock Switch Analysis: “Door Won’t Unlock”368. No Output Voltage to Components409. No Motor Operation With No AC Drive Fault4410. No Motor Operation With AC Drive Fault4811. The Motor is Running, But at an Abnormal Speed52Preliminary Checks:52Secondary Checks:52Calibration of the Machine5212. No Spin5313. Machine Did Not Fill Alarm Analysis5414. Empty Alarm Analysis5815. Automatic Supply Dispenser Analysis6216. No Keypad Board Functions6417. Excessive Cycle Time6518. Excessive Vibration and/or Noise During Spin66Service Procedures6719. Top Cover Removal and Replacement6720. Keypad Removal and Installation6721. Computer Board Removal and Installation6822. Keymode Switch Removal and Installation7123. AC Drive Switch Removal and Installation7224. Rear Panel Removal and Replacement7325. Side Panel Removal and Installation7326. Drive Belt Removal and Replacement7427. Water Valve Removal and Replacement7528. Drain Valve7629. Door Gasket Removal and Replacement7630. Motor Removal and Replacement (18, 25, 35, 55 and 75-Pound Capacity Models)7731. Motor Removal and Replacement (100, 135 and 165-Pound Capacity Models)78サイズ: 3.74MBページ数: 78Language: Englishマニュアルを開く