ユーザーズマニュアル目次Installation Sheet1Enrolling1Lock1Press once for Arm-Away mode.1Unlock1Press the unlock button to disarm your system. You do not have to enter your access code when you use this key to disarm the system.1Auxiliary1Press the “1” button once for Arm-Stay mode, twice for Stay Instant mode, and three times for Stay Night mode.1The “2” button's function depends on the individual panel programming. Refer to the installation instructions for your panel.1Panic or Aux1If the keyfob is programmed using a panic group number, pressing the buttons and simultaneously will activate an audible or silent panic alarm (depending on a group number) and initiate reports to the central station. Similarly, if the keyfob is progr...1LED indications1Every event sent from the keyfob to the panel is signaled with a single flash of the green LED.1Also, the following panel events are transmitted to the keyfob, and indicated by the keyfob's LED state:1System disarmed = Green flashing LED for 1 second.1System armed (away and stay) = Red flashing LED for 1 second.1System in alarm (intrusion event, life safety) = LED alternates flashes between red and green 2 times, then stays red for 3 seconds indicating an alarm condition.1System trouble (can’t arm) = LED flashes yellow for 1 second.1Keyfob low battery = LED flashes yellow 3 times.1In case the user is out-of-range of the receiver, this will be indicated with the LED flashing yellow 2 times. The keyfob will send a low battery signal when the battery voltage goes below 2.2 V and it will also be reported to the panel if the keyfob ...1Stay mode options1Single press of the “1” button makes the normal Stay mode active – interior zones are bypassed. If you press the button again, Stay Instant mode activates − your entry/exit delay zones will not be bypassed anymore and will become instant. If you press...1Replacing the Battery1Because keyfobs are non-supervised devices, a low battery signal will only be received by the control panel when the device is within range of the receiver and a button is pressed (a low battery signal will only be sent when a button is pressed). When...1Steps for replacing the battery:21. With a key or small screwdriver, press the black tab located at the bottom of the remote (Figure 1) and slide the chrome trim off.22. Carefully separate the front and back piece of plastic to reveal the battery.23. Replace with a CR2032 battery ensuring the + side of the battery faces up (Figure 2).24. Re-assemble the plastics and ensure they click together.25. Ensure the notch in the chrome trim is aligned with the back of the plastic. It will only go on one way (Figure 3).2Specifications2サイズ： 259KBページ数： 3Language: Englishマニュアルを開く
