ユーザーズマニュアル目次BEFORE YOU BEGIN...................................................................................... 12IMPORTANT SAFETY NOTICES..................................................................... 22CAGE HARDWARE PACK……….....….............................................................42CAGE ASSEMBLY INSTRUCTIONS.................................................................62CAGE EXPLODED DIAGRAM.......................................................................…142CAGE PARTS LIST…………………………………………………………………. 152BENCH HARDWARE PACK……….....…..................................................…….162BENCH ASSEMBLY INSTRUCTIONS......................................................…….182BENCH EXPLODED DIAGRAM...............................................................……. 232BENCH PARTS LIST……………………………………………………………….. 242WARRANTY.................................................................................................… 252ORDERING PARTS......................................................................................... 252CAGE HARDWARE PACK6CAGE ASSEMBLY INSTRUCTION7Attach a Ø 2 ½” Rubber Bumper (#29) and the Weight Storage Post (#14) to Right Stabilizer (#3). Secure it with one M10 x ¾” Allen Bolt (#50) and Ø ¾” Washer (#52).7Note: Do not tighten the Nuts and Bolts in following steps until instructed to do so.7Connect the Right and Left Stabilizer (#2 & #3) by the Rear Base Frame (#4). Secure each end of the Rear Base Frame to each Stabilizer with four M10 x 2 3/8” Carriage Bolts (#43), one 4 ¾” x 3 ¼” Bracket (#17), four Ø ¾” Washers (#52), and four M10 Aircr7Attach an Upright Beam (#1) onto the Right Stabilizer. Secure it with four M10 x 2 3/8” Carriage Bolts (#43), four Ø ¾” Washers (#52), and four M10 Aircraft Nuts (#54). Repeat the same step to install the other Upright Beam to the Left Stabilizer.7Attach the Top Beam (#5) to the two Upright Beams. Secure each end of the Top Beam with one M10 x 4 1/8” Allen Bolt (#45) to the upper hole, one M10 x 4 1/8” Carriage Bolt (#40) to the lower hole, one 4” x 2 3/8” Curved Bracket (#16), two Ø ¾” Washers (#7DIAGRAM 18CAGE EXPLODED DIAGRAM15CAGE PART LIST16KEY NO. DESCRIPTION Q’ty16BENCH PARTS LIST25KEY NO. DESCRIPTION Q’ty25サイズ: 2.73MBページ数: 26Language: Englishマニュアルを開く