ユーザーズマニュアル目次1 Remove the grids and all the caps and flame-spreader crowns;32 Unscrew the burner nozzles with a 7 mm socket wrench;33 Replace the nozzles according tothe type of gas to be used (see point “4”).34 Replace the burners in the correct position.3サイズ： 228KBページ数： 5Language: Englishマニュアルを開く
ユーザーガイド目次Important safety instructions22. COOKTOP MEASUREMENTS33. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTS41 Remove all packaging parts (e.g. crate, carton, polystyrene and metal hooks). Do not eliminate this manual as it is an integral part of the appliance and it should be kept handy for easy reference whenever needed.42 Temporarily remove all removable parts from the cooktop that could fall and cause personal injury or damage to objects (burners, crowns and flame caps) during the attachment procedures These parts must be refitted before using the appliance.43.1 Gas supply requirements63.2 Electrical requirements73.2.1 Recommended Grounding Method84. INSTALLING THE COOKTOP91 Unscrew cap A on the pressure regulator92 Turn it to the part where LP is printed93 Re-tighten it and lock the pins in the slots provided.94 There is an arrow printed on the back of the energy regulator. The tip of the arrow indicates the end to be connected to the cooktop connector.95. CHECKING OPERATION121 a spark must light on all burners when the knobs on the top are pressed122 when each knob on the cooktop is pressed and turned to the low flame symbol ( ), the entire crown should light.123 lf burners do not light properly, turn the control knob to the "OFF" position O . Check that burner caps and crowns are in the proper position. Check that the power supply cord is plugged in and that circuit breaker or house fuse has not blown. Che...126. WIRING DIAGRAMS13サイズ： 445KBページ数： 13Language: Englishマニュアルを開く
