Tagsys S.A. RXU500 マニュアル

目次

• Chapter 1: Introduction

  5
  • About this Guide

    5
    • Intended Audience

      5
    • Other Documents of Interest

      5
    • Impinj Support Information

      6
  • Introduction to Speedway® Revolution

    6
  • Requirements for Using Speedway Revolution

    7
    • Environmental Requirements

      7
    • Hardware Requirements

      7
    • Power Requirements

      7
    • Supported Operating Environments

      8
    • Supported Communication Protocol

      8
    • Antenna Requirements

      8
• Chapter 2: Installing and Connecting Speedway Revolution

  9
  • Speedway Revolution Ports and LEDs

    9
  • Installing and Connecting the Reader

    11
  • Detailed Installation Procedures

    11
    • Step 1: Position the Speedway Revolution Reader and (optionally) Mount the Reader

      11
    • Step 2: Connect the Antenna(s) to the Speedway Revolution Reader

      12
    • Step 3: Connect Speedway Revolution to the Network

      12
    • Step 4: Power the Reader

      15
    • Step 5: Test the Installed Reader

      15
• Chapter 3: Configuring and Monitoring Speedway Revolution

  16
  • Configuring Speedway Revolution

    16
    • Device Configuration

      16
      • Using Rshell to Configure Network Settings for Speedway Revolution

        16
    • RF Configuration

      17
      • Using MultiReader to Configure and Test Speedway Revolution

        17
  • Monitoring Speedway Revolution

    21
    • Viewing Network Parameters and Statistics

      21
    • Viewing RFID Parameters and Statistics

      22
    • Configuring and Viewing Speedway Revolution Logs

      22
    • Viewing the State of the Speedway Revolution Device

      23
• Chapter 4: Upgrading the Speedway Revolution Firmware

  24
  • A Brief Overview of the Speedway Revolution Firmware

    24
  • Upgrading the Firmware

    24
• Chapter 5: Troubleshooting

  27
  • Returning to the Factory Default Configuration

    27
  • Submitting Diagnostic Data for Analysis by Impinj Technical Support

    29
• Appendix A: Information Specific to Regions of Operation

  31
  • Operation in North America

    31
    • Frequency Plan

      31
    • Antenna Requirements

      31
      • Positioning

        31
      • Installation

        32
      • Power

        32
      • Approved Antennas

        32
  • Operation in European Union

    33
    • Frequency Plan

      33
    • Antenna Requirements

      33
      • Power

        33
      • Approved Antennas

        34
• Appendix B: GPIO Details

  35