ユーザーズマニュアル目次USC 9330 Quick Start Card11 Connect Your Small Cell1Step 1 Screw the two antennas into the antenna ports on the top of the small cell: Ant1 port=3G antenna, Ant2 port=2G antenna.1Step 2 Seal the antenna ports with waterproof glue or tape to prevent any moisture from penetrating.1Step 3 Mount the USC 9330 small cell on a wall, ceiling or pipe as described in the USC 9330 Installation Guide: http://www.cisco.com/en/US/docs/wireless/...1Step 4 If you are using the DC power option:1Figure 1 USC 9330 Antenna Ports2Figure 2 PSE and USC 9330 Connections2Step 5 If you are using the power over Ethernet (PoE) option:2Step 6 Connect two grounding wires to the grounding screws on the USC 9330.2Step 7 Flip the power switch on the PSE to the appropriate location (1 for DC power and 0 for PoE). The LED on the top of the PSE unit indicates the power mode: Green: PoE; Blue: DC power.22 Verify that the USC 9330 is Operational2Table 1 USC 9330 Status LED Indications23 Safety Instructions1サイズ: 656KBページ数: 3Language: Englishマニュアルを開く