Teledyne powerpod 400 マニュアル

目次

• QUICK START INSTRUCTIONS

  5
• SAFETY

  6
• FEATURES

  7
• SPECIFICATIONS

  9
• FRONT PANEL

  10
• REAR PANEL

  11
• WIRING

  12
• POWER

  12
• COMMUNICATIONS

  12
• TRANSDUCER CONNECTIONS

  13
• ALARMS

  13
• ANALOG SIGNAL FOLLOWERS

  14
• MANUAL OPERATION

  15
• POWER ON/OFF

  15
• CHANGING THE COMMAND SET POINT

  15
• OVERRIDE OPEN

  15
• OVERRIDE CLOSED

  15
• SETTING A CHANNEL TO AUTO CONTROL

  16
• SETTING A CHANNEL TO DIRECTLY METER INCOMING SIGNALS

  16
• SETTING A CHANNEL TO DISPLAY THE TOTALIZER FUNCTION

  16
• EXTERNAL/REMOTE OPERATION

  18
• SELECTING EXTERNAL/REMOTE OPERATION (FRONT PANEL ONLY)

  18
• CHOOSING RS-232 COMMUNICATION

  18
• CHOOSING RS-485 COMMUNICATION

  18
• SETUP/CAL MODE

  19
• ENTERING THE SETUP/CAL MODE

  19
• DISPLAY SETUP

  19
• BLANKING A DISPLAY LINE/CHANNEL

  19
• SELECTING DISPLAY BRIGHTNESS

  19
• SELECTING UNIT-OF-MEASURE

  20
• SELECTING GAS ID

  20
• SETTING A/D CONVERSION RATE (FILTER)

  20
• FRONT PANEL LOCK OUT

  21
• TOTALIZER SETUP

  21
• COUNT UP TO A SET POINT

  21
• COUNT DOWN FROM A SET POINT

  22
• COUNT CONTINUOUSLY

  22
• EXTERNAL COMMUNICATION SETUP

  22
• RS-232 SETTINGS

  22
• RS-485 SETTINGS

  22
• SELECTING THE ANALOG SIGNAL LEVEL

  23
• ZERO TO FIVE VOLT OPERATION

  23
• ZERO TO TEN VOLT OPERATION

  23
• 10.5.3. FOUR TO TWENTY MILLIAMP OPERATION

  23
• 10.6.1. SETTING A SINGLE CHANNEL’S HIGH LIMIT

  24
• 10.6.3. SETTING A SINGLE CHANNEL’S HYSTERESIS

  24
• ENABLING RATIO CONTROL

  25
• 10.8.1. RESETTING THE ZERO ONLY

  26
• 10.8.3. RESETTING ZERO AND SPAN

  27
• 10.9. SERIAL COMMUNICATION

  28
• 10.9.2. SET POINT QUERIES

  28
• APPENDIX A

  30
• APPENDIX B

  33
• APPENDIX C

  33
• APPENDIX D

  36
• DRAWINGS

  41
• WARRANTY

  42
• WARRANTY REPAIR POLICY

  42
• NON-WARRANTY REPAIR POLICY

  42