ユーザーズマニュアル目次Product Summary11. If possible, locate sensors within 100 feet of the panel. While a transmitter may have a range...12. The required mounting height is 7 1/2 feet.13. Position the sensor to protect an area where an intruder would be most likely to walk across t...14. Mount the motion sensor on an insulated, outside wall facing in.15. Mount the motion sensor on a rigid surface which is free from vibrations.16. Position the sensor so it faces a solid reference point, like a wall.17. Do not aim the sensor at windows, fireplaces, air conditioners, area heaters, forced air heati...18. Do not mount the sensor near duct work or other large metallic surfaces which may affect the R...19. Mount the sensor permanently on a flat wall or in a corner. Do not set it on a shelf.110. Windows should be closed in any area which has an armed motion sensor.111. The pet must not be allowed to climb on objects such as furniture, boxes, etc. within the fie...112. Room temperature must be kept at 60º F or higher.113. The sensitivity switch must be set to Standard.1Figure 1. Overhead (Bird’s Eye View) Detection Path1Figure 2. This graph shows the top view of the lens coverage area, for the indoor motion sensor’s...2Figure 3. Side view (Motion Sensor) at a mounting height of 7.5 feet.2Mounting the Motion Sensor2Figure 4. Wall mount options2To mount the sensor:21. Remove the mounting plate by depressing the button on the top of the sensor body. With the opp...22. Punch out two of the bottom four mounting holes. See Figure 4 for wall mount options. Use the ...23. If you desire wall-tamper functionality, remove the wall-tamper knockout.2Figure 5. PIR Mounting plate knockouts24. Mark the location of the required holes on the mounting surface.25. Use wall anchors and screws to secure into place. Attach the sensor to the mounting plate.26. When testing is completed the PIR can be securely attached to its mounting plate by screwing t...3Setting the Sensitivity on the Indoor Motion Sensor3Walk Testing the Motion Sensor31. Remove the sensor body from the mounted mounting plate, activate the tamper switch, and then r...32. Walk across the coverage pattern to determine the coverage area, indicated by LED activation. ...3Environment Testing3Programming3To trip the sensor:31. Remove the back cover to activate the tamper switch.32. Exit the panel’s programming mode.33. Return the PIR to its mounting plate.3Maintenance3Replacing Batteries3Final Testing31. After the sensor has been mounted, remove it from its mounting plate and activate the tamper s...32. Replace the sensor in its mounting plate33. Place the control panel in test mode. Move across the detection pattern until the sensor’s LED...34. Listen for the appropriate system response. If the system does not respond, proceed to Trouble...3Troubleshooting3To relocate a sensor:31. Test the sensor a few inches from the original position.32. Increase the distance from the original position and retest until an acceptable location is fo...33. Mount the sensor in the new location.34. If no location is acceptable, test the sensor as follows:3Specifications4Notices4ITI® Aritech APW 450 PIR Motion Sensor1サイズ： 133KBページ数： 4Language: Englishマニュアルを開く
