ATN 4X12 사용자 설명서
3
4
WINDAGE AND ELEVATION
The vertical and horizontal adjustments
for the ATN 4X12° SWAT can be achieved
by turning the elevation and windage
adjustment mechanisms (remove dust
caps first). Each click equals to 1/8 inches
for the ATN 4X12° SWAT can be achieved
by turning the elevation and windage
adjustment mechanisms (remove dust
caps first). Each click equals to 1/8 inches
at 100 yards. When reaching the maxi-
mum of rotation do not use force.
mum of rotation do not use force.
ZEROING
Pre-zeroing is recommended and can be
done in accordance with a scope guide or
owner’s instructions.
CAUTION: Be sure gun is not loaded.
Always use safe gun handling proce-
dures.
All shooting should be done at an
approved range or other safe area. Eye
and ear protection is recommended.
DANGER: If you used a bore-obstruct-
done in accordance with a scope guide or
owner’s instructions.
CAUTION: Be sure gun is not loaded.
Always use safe gun handling proce-
dures.
All shooting should be done at an
approved range or other safe area. Eye
and ear protection is recommended.
DANGER: If you used a bore-obstruct-
ing device, remove it before proceed-
ing. If the barrel has-been drilled for
a mount, check that the screws do
not protrude into the bore. Do not fire
live or even blank ammunition with
an obstructed barrel. An obstruction
can cause serious damage to the gun
and possible injury to you and others
nearby.
From a steady position, fire three rounds
at a target. Observe the impact errors
and estimate the correction value. Adjust
windage and elevation handles as needed
to correct aim.
From a steady position, fire three rounds
at a target. Observe the impact errors
and estimate the correction value. Adjust
windage and elevation handles as needed
to correct aim.
Remove the dust caps from the top of the
windage and elevation adjusting handles.
Turn the windage and elevation handles
through the number of clicks necessary
for an amendment.
windage and elevation adjusting handles.
Turn the windage and elevation handles
through the number of clicks necessary
for an amendment.
NOTE: Each click of adjustment changes
bullet strike by the amount shown on the
chart below.
Windage/Elevation
chart below.
Windage/Elevation
(inches of movement per click)
100 Yards - 1/8”
200 Yards - 1/4”
300 Yards - 3/8”
400 Yards - 1/2”
500 Yards - 5/8”
200 Yards - 1/4”
300 Yards - 3/8”
400 Yards - 1/2”
500 Yards - 5/8”
When you have finished adjustment of
fire, recap windage and elevation mecha-
nisms.
fire, recap windage and elevation mecha-
nisms.
ELECTRONIC RETICLE
Your scope has an electronic Tacti-
cal Ring and Dot reticle. There are 11
degrees of illumination. The rheostat is
the knob located at the back of the scope.
It is labeled with numbers OFF through 11.
When the rheostat is set at OFF you will
see a black etched reticle. The reticle will
light up red electronically as you rotate the
rheostat through the numbers, 11 being
the brightest.
cal Ring and Dot reticle. There are 11
degrees of illumination. The rheostat is
the knob located at the back of the scope.
It is labeled with numbers OFF through 11.
When the rheostat is set at OFF you will
see a black etched reticle. The reticle will
light up red electronically as you rotate the
rheostat through the numbers, 11 being
the brightest.
Windage
Elevation
Dust caps
2 MOA
70 MOA