iOptron 3130 사용자 설명서

2.  If there is no illumination LED installed, please follow the procedures bellow to install it. 

Release four (4) screws from the SmartEQ face plate, as shown in Figure 5.  

 

 

Figure 5. Remove face plate screws 

 
 
 

 

 

 

Figure 6. Disconnect cables 

 

 

3.  Carefully pull the face plate open. Disconnect the RA and DEC motor drive cables first. Then 

disconnect two battery holders from the main board. 

4.  Lay the face plate with main control board on a table. Align the illumination LED to the top edge 

of the board, make sure plus (+) and minus (-) electrodes of the LED are aligned to the + and – 
signs on the board, as shown in Figure 7. 

 

 

Figure 7. Align LED to the main board 

Motor cables 

Battery cables