Roland CD-2e 사용자 설명서
22
Turning the Power On and Off
(continued)
fig.battery06-e.esp
1
Turn the power off.
Disconnect all cables from the CD-2e.
2
Turn the CD-2e upside down and remove the battery cover.
* When turning the CD-2e upside down, place stacks of newspapers or magazines to support the
four corners (or two sides) so that stress is not placed on the buttons or knobs, possibly damaging
them. Also, handle the CD-2e with care, and avoid dropping it.
them. Also, handle the CD-2e with care, and avoid dropping it.
fig.battery01-e.esp
3
Install six AA alkaline batteries.
fig.battery02-e.esp
4
Close the battery cover and turn the CD-2e right side up.
5
On the CD-2e’s rear panel, set the [POWER] switch to the “ON” position.
When the power is turned on, the screen will light.
fig.power-on-battery.eps
Using Batteries
If you’re operating the CD-2e on batteries, you won’t be able to perform CD-related
operations such as recording, playing, or writing songs, etc.
operations such as recording, playing, or writing songs, etc.
Note
Batteries to use
AA alkaline batteries
* You cannot use zinc-carbon batteries or rechargeable batteries (such as
rechargeable nickel metal hydride batteries).
rechargeable nickel metal hydride batteries).
Battery cover
Press here and pull upward.
* Make sure that the “ ” and “ ” are oriented correctly.
CD-2e_e.book 22 ページ ２００７年９月１０日 月曜日 午後８時５７分