Peerless Industries PM 20C 사용자 설명서

ISSUED: 07-17-96  SHEET #: 170-9001-7  10-26-04

Visit the Peerless Web Site at www.peerlessindustries.com

For customer service call 1-800-729-0307 or 708-865-8870.

Before you start make sure all of the parts
shown are included with your product. See page
5 for a complete parts list.

Wood Stud, Wood Beam

none

Solid Concrete, Cinder

Contact Customer Service for accessory kit

Block

unless you have a PM 20C or PM 27C which
includes concrete fasteners

Metal Stud (Attachment to

Do not attach except with Peerless accessory kit

metal studs has not been

for metal studs; Contact Customer Service for

evaluated by UL and the

Peerless accessory kit for metal studs.

product is not UL listed if
attached to metal studs.)

Other or unsure?

Contact Customer Service

• Do not begin to install your Peerless product until you have read and understood the instructions and warnings

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call
Peerless customer service at 1-800-729-0307.

• This product should only be installed by someone of good mechanical aptitude, has experience with basic

building construction, and fully understands these instructions.

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached

hardware and components.

• Never mount this product to a metal stud wall construction unless the stud can be verified to be constructed of

25 gauge steel minimum, the drywall is 1/2" thick minimum and you obtain and use the Peerless accessory kit
for metal studs.

• Never exceed the Maximum UL Load Capacity.

• If mounting to wood wall stud wall construction, make sure that mounting screws are anchored into the center of

the studs. Use of an "edge to edge" stud finder is highly recommended.

• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws and nuts firmly, but do not overtighten. Overtightening can damage the items, greatly reducing

their holding power. See suggested torque values where applicable within these instructions.