Peerless Industries ST650P 사용자 설명서

ISSUED: 11-21-07  SHEET #: 202-9255-2 02-22-08

Visit Peerless website at www.peerlessmounts.com

For customer care call 1-800-729-0307 or 708-865-8870

• Do not begin to install your Peerless product until you have read and understood the instructions and warnings

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.

• This product should only be installed by someone of good mechanical aptitude, has experience with basic building

construction, and fully understands these instructions.

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-

ware and components.

• Never exceed the Maximum UL Load Capacity. See page one.

• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an

"edge to edge" stud finder is highly recommended.

• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding

power.

• This product was designed and intended to be mounted to the following supporting surfaces checked below with the

hardware included in this product as specified in the installation sheet. To mount this product to an alternative support-
ing surface, contact Peerless customer care at 1-800-865-2112.

• This product was designed to be installed on the following wall construction only;

Wood Stud

None

Wood Beam

None

Solid Concrete

None

Cinder Block

None

Metal Stud

Do not attach except with Peerless accessory kit for metal studs;
Contact Customer Service for Peerless accessory kit for metal studs.

Brick

Contact Customer Service

Other or unsure?

Contact Customer Service

NOTE: Read entire instruction sheet before you start installation and assembly.

• stud finder ("edge to edge" stud finder is recommended)

• phillips screwdriver

• drill

• 1/4" bit for concrete and cinder block wall

• 1/2" bit for metal stud wall

• 5/32" bit for wood stud wall

• level

Parts List .............................................................................................................................................................................. 3

Installation to Double Wood Stud Wall .................................................................................................................................. 5

Installation to Solid Concrete or Cinder Block ....................................................................................................................... 6

Installing Adapter Brackets ................................................................................................................................................... 7

Mounting and Removing Flat Panel Screen ........................................................................................................................... 9

• ACC415 - Metal Stud Fastener Kit  (Metal Stud not
evaluated by UL)

• SCS221- SmartMount

®

 A/V Component Shelf