Peerless Industries SF680 사용자 설명서

ISSUED: 11-09-07 SHEET #: 202-9253-4  08-31-10

•  Do not begin to install your Peerless product until you have read and understood the instructions and warnings 

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US 
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact 
your local distributor.

•  This product should only be installed by someone of good mechanical aptitude, has experience with basic building 

construction, and fully understands these instructions.

•  Make sure that the supporting surface will safely support the combined load of the equipment and all attached 

hardware and components.

•  Never exceed the Maximum Load Capacity. See page one.

•  If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of 

an "edge to edge" stud fi nder is highly recommended.

•  Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding 

power.

•  This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal 

injury.

•  This product was designed to be installed on the following wall construction only;

  WALL CONSTRUCTION 

Wood 

Stud   Included

  •  Wood Beam 

 

 

Included

  •  Solid Concrete 

 

 

Included

  •  Cinder Block 

 

 

Included

  •  Metal Stud 

 

 

Do not attach except with Peerless Metal Stud Accessory Kit - ACC615; 

 

 

    (not 

evaluated 

by 

UL)

  •  Brick 

   Contact 

Qualifi ed Professional (not evaluated by UL)

  •  Other or unsure?   

 

Contact Qualifi ed Professional

NOTE: Read entire instruction sheet before you start installation and assembly. 

Parts List.................................................................................................................................................................................3

Installation to Triple Wood Stud Wall ......................................................................................................................................4

Installation to Solid Concrete or Cinder Block ........................................................................................................................5

Installing Adapter Brackets .....................................................................................................................................................6

Installing Flat Panel Screen to Wall Plate ...............................................................................................................................8

• stud fi nder ("edge to edge" stud fi nder  is recommended)

•  phillips screwdriver

• drill 

•  5/16" (8 mm) bit for concrete and cinder block wall

•  5/32" (4 mm) bit for wood stud wall

•  level