Peerless Industries ST630P 사용자 설명서

ISSUED: 02-05-09   SHEET #: 201-9421-9  06-03-09

Make sure that tilt assembly (

B) is level, use it as a 

template to mark two mounting holes. Drill two 5/16" 

(8 mm) dia. holes to a minimum depth of 2.5"  

(64 mm). Insert anchors (

C) in holes flush with wall 

as shown (right). Place tilt assembly over anchors 

and secure with two #14 x 2.5" screws (

G). Level, 

then tighten all fasteners.

CINDER BLOCK

SOLID CONCRETE

Drill holes and insert anchors (

C).

Place plate (

B) over anchors (C) and secure with screws (G).

Tighten all fasteners.

concrete 

surface

1

•  When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" (35 mm) of actual 

concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount 

in a solid part of the block, generally 1" (25 mm) minimum from the side of the block. Cinder block must meet ASTM 

C-90 specifications. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a 

hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

•  Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
•  Make sure that the wall will safely support four times the combined load of the equipment and all attached hardware 

and components.

wall 

plate

wall 

plate

plaster/

dry wall

plaster/

dry wall

concrete

concrete

•  Tighten screws so that wall plate is firmly attached, 

but do not overtighten. Overtightening can damage 

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).
•  Always attach concrete expansion anchors directly 

to load-bearing concrete.

•  Never attach concrete expansion anchors to 

concrete covered with plaster, drywall, or other 

finishing material. If mounting to concrete surfaces 

covered with a finishing surface is unavoidable, 

the finishing surface must be counter bored as 

shown below. Be sure concrete anchors do not 

pull away from concrete when tightening screws. 

If plaster/drywall is thicker than 5/8" (16 mm), 

custom fasteners must be supplied by installer (not 

evaluated by UL).