Peerless Industries SWS320/SI 사용자 설명서

ISSUED: 11-21-07   SHEET #: 202-9255-5   05-12-10

To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen. Place 
screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be attached. 
Place adapter brackets (BB or CC) on back of screen, align to holes, and center on back of screen as shown 
below. Attach the adapter brackets to the back of the screen using the appropriate combination of screws, multi-
washers, and spacers as shown in fi gure 2.1 or 2.2. 

NOTE: For fl at back screens proceed to step 2-1. For bump-out or recessed back screen skip to step 2-2.

NOTE: "X" dimensions should be equal.

CENTER BRACKETS 

VERTICALLY ON BACK 

OF SCREEN

HANDLES 

FACE OUT

Notes: 

•  The number of fasteners used will vary, 

depending upon the type of screen.

•  Multi-washers and spacers may not 

be used, depending upon the type of 
screen.

•  Use the corresponding hole in the multi-  

washer that matches your screw size as 
shown.

MEDIUM HOLE FOR M5 SCREWS

SMALL HOLE FOR M4 SCREWS

LARGE HOLE FOR M6 SCREWS

MULTI-WASHER

NOTE: Be sure to attach tilt brackets with handles facing outward as shown below. Verify that all holes are properly 
aligned, and then tighten screws using a phillips screwdriver.

•  Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening 

can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to 
become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

•  If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly 

secured, damage may occur to screen or product may fail.