Peerless Industries SA730P 사용자 설명서

다운로드
페이지 29
2 of 29
ISSUED: 05-09-05  SHEET #: 095-9224-9   12-05-09
Note: Read entire instruction sheet before you start installation and assembly.
Table of Contents
Parts List.................................................................................................................................................................................3
Installation to Wood Stud Wall ................................................................................................................................................4
Installation to Solid Concrete and Cinder Block .....................................................................................................................5
Tools Needed for Assembly
•  stud finder ("edge to edge" stud finder is recommended)
• level
•  5/16" (8 mm) drill bit for concrete and cinderblock walls
•  5/32" (4 mm) drill bit for wood stud walls
•  Do not begin to install your Peerless product until you have read and understood the instructions and warnings 
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US 
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact 
your local distributor.
•  This product should only be installed by someone of good mechanical aptitude, has experience with basic building 
construction, and fully understands these instructions.
•  Make sure that the supporting surface will safely support the combined load of the equipment and all attached 
hardware and components.
•  Never exceed the Maximum UL Load Capacity. See page one.
•  If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of 
an "edge to edge" stud finder is highly recommended.
•  Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•  Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding 
power.
•  This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal 
injury.
•  This product was designed to be installed on the following wall construction only;
  WALL CONSTRUCTION 
 
HARDWARE REQUIRED
 • 
 
Wood 
Stud   Included
    Wood Beam 
 
 
Included
    Solid Concrete 
 
 
Included
    Cinder Block 
 
 
Included
  •  Metal Stud 
 
 
Do not attach except with Peerless Metal Stud Accessory Kit 
 
 
    (not 
evaluated 
by 
UL)
  •  Brick 
 
 
 
Contact Qualified Professional (not evaluated by UL)
  •  Other or unsure?   
 
Contact Qualified Professional
WARNING