Peerless Industries PWS421 사용자 설명서

ISSUED: 02-05-09   SHEET #: 202-9272-4   04-12-10

CENTER BRACKETS VERTICALLY ON BACK 

OF SCREEN

HANDLES FACE OUT

Note: "X" dimensions should be equal.

MULTI-WASHER

MEDIUM HOLE FOR M5 SCREWS

SMALL HOLE FOR M4 SCREWS

LARGE HOLE FOR M6 SCREWS

Notes: 

•  The number of fasteners used will vary, depending 

upon the type of screen.

•  Multi-washers and spacers may not be used, 

depending upon the type of screen.

•  Use the corresponding hole in the multi-washer 

that matches your screw size as shown.

To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen. Place 
screen face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs, 
base, cover or screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the tilt 
brackets to be attached. Select the small, medium, large or extra large screws from the baffl ed fastener pack then 
attach tilt brackets to screen following fi gure 2.1 or 2.2.

NOTE: Be sure to attach tilt brackets with handles facing outward as shown below. Verify that all holes are properly 
aligned, and then tighten screws using a phillips screwdriver.

•  Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening 

can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to 
become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

•  If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly 

secured, damage may occur to screen or product may fail.

NOTE: For fl at back screens proceed to step 2-1. For bump-out or recessed back screen skip to step 2-2.