Peerless Industries IM740P 사용자 설명서

ISSUED: 12-04-07  SHEET #: 095-9280-3   03-25-10

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-865-2112 or 708-865-8870.

•  Installer must verify that the supporting surface will safely support the combined load of the equipment and all

attached hardware and components.

•  Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).
•  Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder

is highly recommended.

•  hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-

ers are responsible to provide hardware for other types of mounting situations. 

fLANgE

fLANgE

In-wall box (

A) must be installed between two studs 16" on

center. Use an edge-to-edge stud finder to locate the edges

of the stud. Based on its edges, draw two vertical lines down 

the inside edges of stud’s. Mark desired center of in-wall box. 

Draw a horizontal line 6-1/8" (150 mm) above center of in-wall

box (

A). Draw a second horizontal line 12-1/4" (311 mm) below

this line to outline wall opening between inside edges of studs. 

Remove drywall inside cut outline.
NOTE: In-wall box (A) can be installed for left or right side 

mount orientation as shown in figure 1.2.
Insert in-wall box (

A) into cut-out until flange is flush with

drywall.
Level in-wall box (

A), and mark the position of two mounting 

holes using holes on mounting tabs.  Remove in-wall box (

A) 

and drill 1/8" (3 mm) dia. holes 1-1/2" (38 mm) deep using

the locations previously marked.  Reinstall and level in-wall 

box (

A). Secure using two #10 X 1-1/2" wood screws (B) as 

shown in figure 1.3.
Attach two mounting cover plates (

C) to in-wall box (A) using 

four ribbed rivets (

D) as shown in figure 1.4.

12-1/4"

(311mm)

14.5"

(368mm)

STUD

6-1/8"

(150mm)

CUT 

OUTLINE

CENTEr Of  

IN-WALL BOX

MOUNTINg

TABS