Peerless Industries PA730 사용자 설명서

ISSUED: 06-18-07   SHEET #: 095-9269-5   06-05-09

AA wall arm assembly

1

095-P1628

095-4268

M4 x 12 mm phillips screw

4

504-9013

504-2014

M4 x 20 mm phillips screw

4

504-9020

504-2013

retaining spacer

4

590-5005

590-5003

#14 x 2.5" wood screws

2

520-1202

520-2165

5 mm allen wrench

1

560-9640

560-9640

concrete anchor

2

590-0320

590-0320

G cable ties

2

560-9711

560-2004

cable tie anchor

2

590-1290

590-1290

3/16" allen wrench

1

560-0071

560-0071

8-32 x 1/4" flat head screw

2

520-1622

520-2622

•  Installer must verify that the supporting surface will 

safely support the combined load of the equipment 
and all attached hardware and components.

•  Tighten wood screws so that wall plate is firmly at-

tached, but do not overtighten. Overtightening can 
damage the screws, greatly reducing their holding 
power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).

•  Make sure that mounting screws are anchored into 

the center of the stud. The use of an "edge to edge" 
stud finder is highly recommended.

Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to 
edge stud finder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall 
plate as template to mark center of holes along the vertical line. Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm) 
deep. Attach wall arm assembly (AA) to wall using two #14 x 2.5” flat head wood screws (D) as shown in figure 
1.1.

1

WOOD STUD WALL