Sanus Systems SSMK1 사용자 설명서

Sanus Systems  2221 Hwy 36 West, Saint Paul, MN  55113  USA

Customer Service: 1-800-359-5520 • info@sanus.com • www.sanus.com

(6901-300182 <01>)

Thank you for choosing the Sanus Systems Steel Stud Mounting Kit.  The SSMK1 is designed to be used in conjunction 
with the following Sanus Systems wall mounts: 

Mount   

 

 

Maximum weight capacity 

 

Maximum size capacity

VMPL250, VMPL50 

 

59 kg (130 lbs)   

 

 

50 in (127 cm)

VMPL, VMPL2 

 

 

79 kg (175 lbs)    

 

 

60 in (152 cm)

VMPL3   

 

 

127 kg (280 lbs)   

 

 

84 in (213 cm)

This product is designed for use in steel stud walls only! Studs must be at least 2x4 / 25ga, and the wall must be 
capable of supporting up to five times the weight of the monitor and mount combined. If back side of wall is 
unfinished, drywall must be installed to a minimum of one stud left and right of the stud(s) being used to install 
the mount.  Drywall must be a minimum of 1/2” thick on each side of the studs, and a minimum clearance of 1 
7/8 (48mm) behind the wall is required. This product must be centered on the studs. 

If you have any doubts about the ability of the wall to support the total weight of the monitor and mount, 
contact Sanus Systems Customer Service, or a qualified contractor.

Stud type and structural strength must conform to the North American
Specification for the Design of Cold-Formed Steel Structural Members.
[362 S 125 18, C-Shape, S - Stud Section]

Drywall must be secured to studs with screws 12" on center.

Do not use this product for any purpose not explicitly specified by Sanus Systems. Improper installation may 
cause property damage or personal injury. If you do not understand these directions, or have doubts about the 
safety of the installation, contact Sanus Systems Customer Service or call a qualified contractor. Sanus Systems 
is not liable for damage or injury caused by incorrect mounting, assembly, or use.