Canon MiniMote 사용자 설명서

Locate the three position switch within the battery
compartment. Set the switch to the middle position 

 to

enter programming mode.

When programming is complete, set the switch to either
CHILD mode or ADULT mode before replacing the battery 
compartment door.

TV control can be set by inputting the code for your
brand of TV or via a simple code search. Setting TV
control by code input is described in the Quick Start on
page 4.

1.              With your television ON, and the remote in
                 Programming Mode, press the 

     key.

                 The LED blinks twice.
2.              Press the 

 key once.

3.              Press the 

     key once per second until the

                 TV turns off.
4.              Press 

. If the TV turns on, press 

                 to save the TV code.
5.              If the TV does not turn on, press 

     to go

                 to the previous TV code and press 

 to

                 save once the TV turns on.

nOTe: There are over 200 possible codes, so this may
take a few minutes.

MiniMote comes pre-programmed with 8 favourite kids
channels assigned to keys 3 through 0 (refer to Key chart on 
Page 7). The preprogrammed buttons can be programmed 
to new channels by following the steps below.

CaUTIOn: This will program over the channel that was
pre-programmed!

1.              While in 

Programming Mode, press and hold

                 the key that you wish to assign a favourite
                 channel. Release the key when the LED blinks
                 twice.
2.              Press the digits for the channel number for the
                 favourite channel that you wish to add.
3.              Press and hold the key that you wish to assign
                 again until the LED blinks twice.