Honeywell UDC 3300 사용자 설명서

112

UDC 3300 Process Controller Product Manual

4/00

These are the parameters required for Input 1: actuation, transmitter
characterization, high and low range values in engineering units, ratio,
bias, filter, burnout, and emissivity.

Table 4-7 lists all the function prompts in the Input 1 Set Up group and
their definitions.

 ATTENTION  
Changing the input type
will result in the loss of
Field Calibration values
and will restore Factory
Calibration values.

DISABL
B TC
E TC H
E TC L
J TC H
J TC L
K TC H
K TC L
NNM H
NNM L
NM90 H
NM90 L
NIC TC
R TC
S TC
T TC H
T TC L
W TC H
W TC L
100 PT
100 LO
200 PT
500 PT
RAD RH
RAD RI
0-20mA
4-20mA
0-10mV
0-50mV
0-5 V
1-5 V
0-10 V
CARBON
OXYGEN

INPUT 1 ACTUATION TYPE – This selection determines
what actuation you are going to use for Input 1.

DISABLE—Disables Input.
B TC—B Thermocouple
E TC H—E Thermocouple High
E TC L—E Thermocouple Low
J TC H—J Thermocouple High
J TC L—J Thermocouple Low
K TC H—K Thermocouple High
K TC L—K Thermocouple Low
NNM H—Ni-Ni-Moly Thermocouple High
NNM L—Ni-Ni-Moly Thermocouple Low
NM90 H—NiMo-NiCo Thermocouple High
NM90 L—NiMo-NiCo Thermocouple Low
NIC TC—Nicrosil-Nisil Thermocouple
R TC—R Thermocouple
S TC—S Thermocouple
T TC H—T Thermocouple High
T TC L—T Thermocouple Low
W TC H—W5W26 Thermocouple High
W TC L—W5W26 Thermocouple Low
100 PT—100 Ohm RTD High
100 LO—100 Ohm RTD Low
200 PT—200 Ohm RTD
500 PT—500 Ohm RTD
RAD RH—Radiamatic RH
RAD RI—Radiamatic RI
0-20mA—0 to 20 Milliamperes
4-20mA—4 to 20 Milliamperes
0-10mV—0 to 10 Millivolts
0-50mV—0 to 50 Millivolts
0-5 V—0 to 5 Volts
1-5 V—1 to 5 Volts
0-10 V—0 to 10 Volts
Carbon
Oxygen