Honeywell UDC 3300 사용자 설명서

146

UDC 3300 Process Controller Product Manual

4/00

TUNE2

Failsafe mode.
LOOP 2 TUNE—Number of times Loop 2 has been tuned
(manually and automatically).

0-9999 (1 = 1000 counts for
output relays 1 and 2)

Shows the value of Counter 1.  Read only.

Same as COUNTER1

Counter 2 counts the number of times the selected event
has occurred.

Same as COUNTS1

Shows the value of Counter 2.  Read only.

Same as COUNTER1

Counter 3 counts the number of times the selected event
has occurred.

Same as COUNTS1

Shows the value of Counter 3.  Read only.

0-9999

PASSWORD—Entering the designated number resets to
zero the timer or counter specified by Reset Type.
To designate a number as the password:
1. Set all timers and counters to DISABL.
2. Enter the desired PASSWORD (0-9999).
3. Select a Reset Type (next prompt).  The PASSWORD

goes into effect when you press  FUNC  , that is, you can

use it to reset the counters and timers.

NONE
TIMER1
TIMER2
TIMER3
ALL TM
COUNT1
COUNT2
COUNT3
ALL CO
ALL TC

RESET TYPE—Select which timers and/or counters will
be reset to zero when the PASSWORD is entered.

NONE—No values will be reset
TIMER 1 will be reset
TIMER 2 will be reset
TIMER 3 will be reset
ALL TIMERS will be reset
COUNTER 1 will be reset
COUNTER 2 will be reset
COUNTER 3 will be reset
ALL COUNTERS will be reset
ALL TIMERS AND COUNTERS will be reset

The prompts used here are for determining the reason for a controller
failure. Refer to the Section 8 – Troubleshooting in this manual for
complete information.