Honeywell UDC 3300 사용자 설명서
4/00
UDC 3300 Controller Product Manual
149
Check the displays and
keys
keys
Use the procedure in Table 5-2 to run the display and key test.
Table 5-2
Procedure for Testing the Displays and Keys
Press
Result
SET UP
and hold in,
then
FUNCTION
LOOP 1/2
at the same time
The controller will run a display test. All the displays will
light for 8 seconds, then the displays will look like this:
light for 8 seconds, then the displays will look like this:
try all
Lower Display
keys
Upper Display
Press each key to see if it
works
When the key is pressed, the lower display will indicate the
name of the key pressed.
name of the key pressed.
Key Pressed
Lower Display
FUNCTION LOOP 1/2
FUNCTION
LOWER DISPLAY
LWR DISP
MANUAL/AUTO
AUTO MAN
SETPOINT/SELECT
SP SEL
INCRMENT
DECRMENT
RUN/HOLD
RUN HOLD
+
INCRDECR
FUNCTION+SETUP
FUNC SU
If no key is pressed for 20 seconds, the test will time out and the controller
will go into control mode.
will go into control mode.
If any test fails, go to “Controller Failure Symptoms” in Section 9 -
Troubleshooting.
Troubleshooting.
Key error
When a key is pressed and the prompt “KEY ERROR” appears in the
lower display, it will be for one of the following reasons:
lower display, it will be for one of the following reasons:
• parameter is not available,
• not in Set Up mode, press SET UP key first,
• key malfunction, do keyboard test.