Honeywell UDC 3300 사용자 설명서
4/00
UDC 3300 Controller Product Manual
205
Section 6 – Setpoint Ramp/Soak Programming Option
6.1 Overview
What is programming?
The term “programming” is used here to identify the process for selecting
and entering the individual ramp and soak segment data needed to
generate the required setpoint versus time profile (also called a program).
and entering the individual ramp and soak segment data needed to
generate the required setpoint versus time profile (also called a program).
A segment is a ramp or soak function which together make up a setpoint
program. Setpoint Ramp/Soak Programming lets you configure 6 ramp
and 6 soak segments to be stored for use as one program or several small
programs. You designate the beginning and end segments to determine
where the program is to start and stop.
program. Setpoint Ramp/Soak Programming lets you configure 6 ramp
and 6 soak segments to be stored for use as one program or several small
programs. You designate the beginning and end segments to determine
where the program is to start and stop.
Review program data
and configuration
and configuration
While the procedure for programming is straightforward, and aided by
prompts, we suggest that you read “Program Contents” in this section as
well as “Section 3 - Configuration” before doing the setpoint
programming.
prompts, we suggest that you read “Program Contents” in this section as
well as “Section 3 - Configuration” before doing the setpoint
programming.
Fill out the worksheet
Draw a Ramp/Soak Profile on the worksheet provided and fill in the
information for each segment. This will give you a record of how the
program was developed.
information for each segment. This will give you a record of how the
program was developed.
What’s in this section
The table below lists the topics that are covered in this section.
Topic
See Page
6.1
Overview
205
6.2
Program Contents
206
6.3
Drawing a Ramp/Soak Profile
209
6.4
Entering the Setpoint Program Data
211
6.5
Run/Monitor the Program
214