Honeywell UDC 3300 사용자 설명서

14

UDC 3300 Controller Product Manual

4/00

Before mounting the controller, refer to the nameplate on the inside of the
case and make a note of the model number. It will help later when
selecting the proper wiring configuration.

Figure 2-3 shows you the mounting method for the UDC 3300 controller.

Panel

22605

Refer to Figure 2-3 and follow the procedure in Table 2-2 to mount the
controller.

Mark and cut out the controller hole in the panel according to the dimension
information in Figure 2-2.

Remove the screw cover and loosen the screw on the front of the controller.
Pull the chassis out of the case.

Orient the case properly and slide it through the panel hole from the front.

Remove the mounting kit from the shipping container, and install the kit as
follows:
•

Install the screws into the threaded holes of the clips.

•

Insert the prongs of the clips into the two holes in the top and 
bottom of the case.

•

Tighten both screws to secure the case against the panel.

•

Carefully slide the chassis assembly into the case, press to close and 
tighten the screw. Replace the screw cover.