Universal Remote Control URC-100 사용자 설명서
18
T h e U n i f i e r
Navigate to the device that has a button you want in
your macro using the DEVICE buttons. Then press
the button with the command you want. Whenever
a button is pressed, another Macro step is counted
and displayed on the screen.
your macro using the DEVICE buttons. Then press
the button with the command you want. Whenever
a button is pressed, another Macro step is counted
and displayed on the screen.
Don’t worry about the number of steps. Each
macro button can store up to 50 steps, so you are
not likely to run out of steps!
macro button can store up to 50 steps, so you are
not likely to run out of steps!
Note: You can program delays in between commands
by pressing the PAUSE button. Each press adds half a
second to the delay.
by pressing the PAUSE button. Each press adds half a
second to the delay.
Press the LIGHT button to save your macro. The
Unifier will flash SAVED twice in the display.
Unifier will flash SAVED twice in the display.
4
3
PAUSE
Button
Advanced Options:
You can setup a DEVICE button to be a macro by press-
ing Audio and Mute for 3 seconds. Once the display says
SET, press the Device button you wish to set as Macro
button. Then follow steps 3 and 4 to setup the macro.
You can setup a DEVICE button to be a macro by press-
ing Audio and Mute for 3 seconds. Once the display says
SET, press the Device button you wish to set as Macro
button. Then follow steps 3 and 4 to setup the macro.
Another option for DEVICE button macros is to only send
the macro if the button is pressed and held. This is setup
by entering a delay as the first step of the macro. The
amount of delay determines how long the user must press
the button before the macro is sent. The advantage of this
the macro if the button is pressed and held. This is setup
by entering a delay as the first step of the macro. The
amount of delay determines how long the user must press
the button before the macro is sent. The advantage of this
option is that a normal press of the DEVICE button will
simply switch devices without issuing the macro.