Invacare 1600 사용자 설명서
ADJUSTMENTS
24
SECTION 4—ADJUSTMENTS
Adjusting the Frame Column Height
NOTE: For this procedure, refer to FIGURE 4.1.
If the lift seat or stretcher touch the bottom of the bathing system or are too high for the
bathing system, use this procedure to ensure the frame column has been adjusted to the
proper height.
NOTE: The bottom of the seat or the stretcher should be approximately two inches above the bottom
of the bathing system.
bathing system, use this procedure to ensure the frame column has been adjusted to the
proper height.
NOTE: The bottom of the seat or the stretcher should be approximately two inches above the bottom
of the bathing system.
1. Lower the lift. Refer to Raising/Lowering the Bath Lift on page 13.
2. Lock the casters. Refer to Locking and Unlocking the Casters on page 10.
3. Stretchers Only ‐ Perform the following to fold up both ends of the stretcher:
A. Press and hold the button on the stretcher frame.
B. Fold up the end of the stretcher.
C. Repeat STEPS A and B for the other end of the stretcher.
4. Press and hold the release lever.
5. Swing the bottom of the stretcher or seat out and up.
6. Raise or lower the stretcher or seat onto one of the six column stops.
FIGURE 4.1 Adjusting the Frame Column Height
Button
Stretcher Frame
Stretcher End
Stretcher
Column
Stops
Release Lever
Column Stop
Column Stop