Panasonic PV-V4622 사용자 설명서
8
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Connect cable from Antenna/Cable to VCR’s IN FROM ANT.
jack.
jack.
How to Connect
Connect VCR’s OUT TO TV jack to TV’s ANT. IN jack with
included RF Cable accessory.
included RF Cable accessory.
2
1
2
1
IN FROM ANT.
TV
VCR
VHF/UHF
OUT TO TV
IN from
ANT./CABLE
ANT./CABLE
Initial Setup for ANT./Cable
➛
➛
➛
➛
➛ VCR ➛
➛
➛
➛
➛ TV Connection
Doing Initial Setup (Ready to Play)
Turn TV on and tune to channel 3.
Plug VCR Power Cord into AC wall
outlet. VCR comes on and auto
channel and clock set starts.
outlet. VCR comes on and auto
channel and clock set starts.
• If screen at right does not appear,
check VCR - TV connection and, if
TV is tuned to channel 3, try
switching it to channel 4.
TV is tuned to channel 3, try
switching it to channel 4.
• To change VCR’s output channel,
please refer to “VCR’s Output
Channel” on page 13.
Channel” on page 13.
1
2
CH AUTO SET PROCEEDING
CANCEL : STOP
Plugging the AC Power Plug into an AC outlet
WARNING
When using “Nut type” RF coaxial cables,
tighten with fingers only. Overtightening may
damage terminals.
When using “Nut type” RF coaxial cables,
tighten with fingers only. Overtightening may
damage terminals.
Please make all cable or antenna connections before plugging into the AC outlet.
Plugging the VCR Power Cord into an AC wall outlet starts auto channel and clock set.
AUTO CLOCK SET
PROCEEDING
PROCEEDING
CANCEL : STOP
V4622 P1-21 (2nd) [LSQT0509B].p65
2002/05/23, 18:28
8