Optimus 109 사용자 설명서
17
PREPARATION
USING THE REMOTE
CONTROL
CONTROL
Installing the Batteries
To power the remote control, you need two AA
batteries (not supplied). For the best perfor-
mance, use alkaline batteries (such as Ra-
dioShack Cat. No. 23-557).
batteries (not supplied). For the best perfor-
mance, use alkaline batteries (such as Ra-
dioShack Cat. No. 23-557).
Cautions:
• Use only fresh batteries of the required
size and type.
• Never leave dead batteries in the remote
control.
• Dispose of dead batteries promptly and
properly; do not bury or burn them.
Follow these steps to install batteries.
1. Press down on the battery compartment
cover and slide it in the direction of the
arrow to remove it.
arrow to remove it.
2. Insert fresh batteries into the compartment,
as indicated by the polarity symbols (+ and
–) marked inside the compartment.
–) marked inside the compartment.
3. Replace the cover.
Note: If the remote control does not work or
operates poorly, replace both batteries.
operates poorly, replace both batteries.
A Quick Look at the Controls
You can control most of the VCR’s normal op-
erations using the buttons on either the VCR or
the remote control. However, for some fea-
tures, you must use the remote control. The in-
structions in this manual mention only the
remote control’s buttons. The corresponding
buttons on the VCR are shown in the following
table.
erations using the buttons on either the VCR or
the remote control. However, for some fea-
tures, you must use the remote control. The in-
structions in this manual mention only the
remote control’s buttons. The corresponding
buttons on the VCR are shown in the following
table.
DPSS
VIDEO CASSETTE RECORDER
MODEL 109
POWER
ON SCREEN
DISPLAY
CH
CH
INPUT
EJECT
1
2
3
4
5
6
7
8
100/
0
9
TV/VCR MODE LOCK
ZERO BACK
CANCEL
MENU
RECORD
PAUSE
/STILL
/STILL
PLAY
REW
FF
STOP
SET
TAPE SPEED
SLOW
AM/
PM
16-546.fm Page 17 Tuesday, July 20, 1999 4:25 PM