Optimus 109 사용자 설명서

25

1. Turn off the VCR, or press 

 so 

disappears from the VCR’s display.

2. Set the TV to the TV mode.

The antenna or cable signals pass through the
VCR unaffected, as if the antenna or cable
were connected directly to the TV.

1. Press 

 until 

 appears on the

VCR’s display.

2. If you connected the VCR’s 

 jacks to a TV/monitor’s audio/video

input jacks, set the TV to the VIDEO mode.

If you connected the VCR’s 

 jacks to a TV/monitor’s single VHF/

UHF input F-connector or separate VHF F-
connector and UHF input screw terminals:

a. Set the TV to the same channel (3 or 4)

as 

.

b. Set the TV to the TV mode.

Your VCR can receive up to 68 VHF and UHF
channels, and up to 125 cable channels. The
VCR displays the channels as 1–125.

• Channels 2–13 are the same for VHF and

cable TV, and cable companies usually
number them as they appear on the dis-
play.

• Since cable companies sometimes desig-

nate cable channels with letters or letter-
number combinations, a channel number
you see on the VCR’s display might differ
from the channel number displayed on
your cable box. You might need to experi-
ment to determine the proper cable chan-
nel designations for your cable system. For
more information, contact your local cable
company.

To change the channel, press 

or

.

The tuner changes to the next higher or lower
channel stored in its memory.

Note:  If you press 

 when the tuner is at

the highest programmed channel or 

when the tuner is at the lowest programmed
channel, the VCR enters the audio/video mode
and 

 appears on the VCR’s display. Contin-

ue to press 

or 

 until the highest or

lowest programmed channel appears.

To directly select a channel, press the number
buttons on the remote control for the desired
channel.

• Always precede single-digit numbers with

a 0 — for example, 01, 02, etc.

• To enter a three-digit number, first press

 then enter the second and third digits

of the channel number.

16-546.fm  Page 25  Tuesday, July 20, 1999  4:25 PM