Optimus 109 사용자 설명서

36

Note: The QTR information appears on the
TV screen for 10 seconds, then disap-
pears. If the information disappears before
you finish entering all changes, simply
press 

 again.

3. To change the displayed tape speed, press

 so the desired 

 or 

tape

speed appears.

Caution:  Do not change the tape’s speed
during recording. Doing so might cause
playback to jitter at the point where you
changed the tape’s speed.

4. To advance the displayed recording stop

time, either:

• Repeatedly press 

 to

advance the displayed stop time in 10-
minute increments.

• Repeatedly press 

 or 

 to

change the displayed stop time forward
or backward in 1-minute increments.

To check or change the stop time setting dur-
ing QTR, simply press 

 then repeat

Step 4.

When you finish entering, checking, or chang-
ing all the QTR information, simply wait 10 sec-
onds without pressing any key. The QTR
information disappears and the VCR stops re-
cording at the set stop time, then turns itself off.

To cancel the QTR stop time while the VCR is
recording, press 

. Recording contin-

ues.

To completely stop recording, press 

.

• You can program QTR information only

while a tape is recording. You cannot pro-
gram QTR information during playback or
while a tape is stopped.

• To ensure that you record the entire

desired program, start the recording a few
minutes before the start of the program
and set the recording stop time a few min-
utes after the scheduled end of the pro-
gram.

• Be sure the tape length you select for QTR

is long enough to record the entire pro-
gram. Even though you can set the VCR to
record for up to 24 hours, the actual
recording time is limited by the tape’s
length.

You can program the VCR’s automatic timer to
select a channel, start recording at a selected
time, then stop the recording at a selected
time.

You can set up to eight program timers to
record (on the same or different channels) any
combination of events:

• One-time (any time on a specific day within

a 1-year period)

• Daily (any time at the same time every day,

Monday–Friday or Monday–Saturday)

• Weekly (any time at the same time every

week)

Automatic timer recording consists of two
steps: setting the program timer and making
the automatic timer recording.

• You must turn off the VCR for it to make an

automatic timer recording.

• Before you start, make sure the VCR’s

clock is correctly set (see “Setting the
Clock” on Page 22).

16-546.fm  Page 36  Tuesday, July 20, 1999  4:25 PM