Toshiba RD-XV48DTKF 사용자 설명서

26

EN

You can preset an analogue channel manually and 
individually.

In stop mode, press [SETUP]. Select 
“General Setting” using [

Select “Channel” using [

Select “ANALOG Channel Setup” 
using [

U \ D], then press [ENTER].

Select “Manual Tuning” using 
[

U \ D], then press [ENTER].

Select “Position” using [

U \ D], then 

Select the position number you want 
to use using [the Number buttons] or 
[

U \ D], then press [L].

• You can select position number 901-999.
• With [the Number buttons], you only need to 

enter the last 2-digit numbers. 

Select “System” using [

U \ D], then 

Select “L” or “BG” using [

• If your system is SECAM-L, select “L”.
• If your system is PAL-B/G, select “BG”.

Select “Channel” using [

U \ D] to start scanning.

• The tuner will begin to search up or down 

automatically. When a channel is found, the unit 
will stop searching and the picture will appear 
on the TV screen.

• You can select a desired channel number using 

[the Number buttons]. Refer to the following 
Channel Plan table and press the three digits to 
select the channel number.
(To select channel 4, press [0] first and then 
press [0] and [4]. Or press [4] and then “– – 4” 
appears and wait for 2 seconds.)

• If this is the channel you want, press [

[L (SECAM-L)]

[BG (PAL-B/G)]

This unit can receive the Hyper and Oscar 
frequency bands.
• If “Skip” is set to “ON”, select “Skip” using 

U \ D], then press [P]. Select “OFF” using 

U \ D], then press [L].

• If you want to decode scrambled signals, select 

“Decoder” using [

U \ D], then press [P]. Select 

“ON” using [

U \ D], then press [L].

• To store another channel, repeat steps 

 Press [SETUP] to exit.

You can set the unit to skip channels. You can no 
longer receive or watch when you access channels 
using [PROG.

G \ H].

(ANALOG)” on this page.

Select “Position” using [

U \ D], then 

Select the position number you want 
to skip using [the Number buttons] 
or [

U \ D], then press [L].

Select “Skip” using [

U \ D], then 

Select “ON” using [

U \ D], then 

• To skip another channel, repeat steps 

.

Press [SETUP] to exit.

01 – 10

21 – 69

74 – 86

90 – 106

121 – 141

02 – 12

13 – 20

A – H (only ITALY)

21 – 69

74 – 78

X, Y, Z, Z+1, Z+2

80 – 99, 100

121 – 141

E3NG0FD_EN.book  Page 26  Wednesday, January 30, 2008  10:37 AM