Toshiba RD-XV48DTKF 사용자 설명서

36

EN

This unit receives time signals from the analogue / 
DVB channels, and set the clock automatically. Set 
the channel tuning before setting Auto Clock. 

In stop mode, press [SETUP]. Select 
“General Setting” using [

Select “Clock” using [

U \ D], then 

Select “Auto Clock Setting” using 
[

U \ D], then press [ENTER].

Select “ON” using [

U \ D], then 

Press [SETUP] to exit.

B ON\STANDBY] to turn the 

• The Auto clock function is activated.
• This unit will search for the time every time when 

the power is turned off.

• Leave the unit off for about 10 seconds to give it 

time to set the clock.

• If you want to cancel “Auto Clock Setting”, select 

“OFF” using [

U \ D], and then press [ENTER] at 

• The default setting of “Auto Clock Setting” is “ON”.
• The clock may set itself automatically after you 

connect the antenna cable to the unit and plug in the 
mains cable. In this case, the current time will 
appear on the front panel display.

• If there are only analogue channels memorised in 

this unit:
- The channel assigned to “901” must receive the 

PDC signal in order to set the clock automatically.

- The unit will correct the current time by receiving 

PDC broadcasts whenever the power is turned off.

- Between 23:00 and 1:00, the Auto Clock function 

will not operate even when the power is turned off.

• The clock cannot be set automatically if you are not 

receiving a channel in your area that carries a time 
signal. In this case, set the clock manually.

• The unit will also correct the current time 

automatically at 8:00 and 1:10 if the unit is in 
standby mode or if you are watching DVB channel.

In stop mode, press [SETUP]. Select 
“General Setting” using [

Select “Clock” using [

U \ D], then 

Select “Clock Setting” using 
[

U \ D], then press [ENTER].

Default date will appear.

Press [ENTER] again.

Press [

P] to move the cursor to the next field. If 

you want to go back to the previous field, press 
[

U \ D], then press [ENTER].

The clock will start.
• Although seconds are not displayed, they will be 

counted from zero.

Press [SETUP] to exit.

• Your clock setting will be lost if either there is a 

power failure or the unit is unplugged for more than 
30 seconds.

E3NG0FD_EN.book  Page 36  Wednesday, January 30, 2008  10:37 AM